Tricket The most efficient way to clean louvered windows, vertical blinds, glass shelves and wooden shutters. Simply scrub with the Tricket double washer then squeegee off with the Tricket double squeegee. Each tool works both sides at the same time. Squeegee blades and washers are replaceable.
INSTRUCTIONS FOR CLEANING LOUVERED WINDOWS:
Wash with the sponge pads, back and forth, until dirt is dissolved. With the squeegee blades, start from the right and move in one single stroke across to the other side. Do not press too hard. If necessary to repeat with the squeegee, be sure to wet each time. For best results, use one stroke, without stopping.
ADJUSTMENT FOR THICKNESS OF GLASS:
1. Loosen the wingnut.
2. Place the squeegee on each side of surface to be cleaned.
3. Grasp the squeegee blade between the thumb and forefinger and press together.
4. Tighten the wingnut and you have the right adjustment.
An environmentally friendly solution designed to remove cementitious products such as cured concrete, stucco and grout from any surface. Safe for use on glass, tile, flooring, baseboards, equipment, vehicles and more. Can be used for self-leveling materials that contain cement. Will not harm metals
*** NEW *** This new system from Window Cleaning World maximises the amount of pure water you get from your resin.
Comes with the NEW WCW Aluniumium Trolley - Lightweight and easy to grab and lift, very ergonomic design.
SAVE ON Resin Costs by up to 30%
Never get caught on a job with a failing DI tank again - You will always have one tank in reserve.
No longer do you have to throw away resin when it produces a TDS of about 30 (when it starts to produce spotting) It is still removing most of the disolved salts and sending pre filtered water to Tank No. 2
Instead keep using the resin in Tank No.1 until it is completely exhausted and stops reducing the Input TDS.
Then renew the resin and put Tank No.2 in the No.1 position and the fresh resin tank in the No. 2 position
Effectively doubles the"column height" of the resin, thus working far more efficiently than a "squat" 12.5 ltr system
No tools required for removing tanks for resin change - it is a simple 10 minute job.
Includes a Combo TDS/Flow meter to monitor the TDS on tank 1 and keeps a tally of water used. Please note that the flow rate is not accurate as it is designed for flows between 3-100 ltr/min. Typical WFP use is about 1-2 litres/min. After a while you will be able to gauge resin use better by the flow totals. Keep a record...
Dual TDS meter measures Tap water (after prefiltration) and also the final tank 2 output.
Includes 2 separate pre-filters - sediment and carbon filters
Inlets and outlet fitting swivel in all directions - stops hoses from kinking
Excludes DI Resin - needs 16 litres to fill both tanks