Supreme™ – Extra wide splaying bristles – feels very soft and easy on the glass whilst also providing some sill cleaning ability. Minimum pressure needed to achieve an easy splay of bristles with low frame impact due to compact & rounded edge stock design.
Dual Trim - inner bristles are a shorter length - allows for easy splay
Flocked & TaperTec™ Bristles give Super-soft feel on the glass & great cleaning power
Best suited to a precise and minimal pressure working method
Stock Dimensions - 232mm x 37mm, Bristle Dimensions - 29cm (11.5") x 12cm (5")
Large Bristle Splay Area - 348cm² - increases to 448cm² under full working pressure
Comes with 1 set of 2mm pencil jet capsules, jet hose and T Connector in the price
If using fanjets, some bristles may need trimming to allow full spray width
Suitable for use with water temperatures up to 30°C
If using this brush on a pole with a Swivel Gooseneck - you will need to pull out a little more of the gooseneck hose from the gooseneck and put an O-Clip around it so that it doesn’t pull back through the gooseneck and impede the swivel action, this will also prevent damage to the Jet Capsule
If using this brush on a pole equipped with a pull on/off internal flow valve, such as a Univalve - you will need to have a hose clip or similar fitted above the gooseneck to prevent the gooseneck hose being pulled back into the pole which would tug on the jets and could lead to damage of the jets with long term use. Such damage would not be covered under warranty
Six month manufacturing defect warranty
TaperTec™ - finely tapered synthetic bristles with a dual height and dual bristle tip type. The very finely tapered bristles tips mimic the effect of natural bristle material such as boars hair, but with greater consistency. This allows for a soft feel that reacts on a very minute level with the dirt adhering to the glass surface. The slightly shorter blunt end bristles in each bunch then can act more aggressively when pushed slightly harder into the glass.
Tricket The most efficient way to clean louvered windows, vertical blinds, glass shelves and wooden shutters. Simply scrub with the Tricket double washer then squeegee off with the Tricket double squeegee. Each tool works both sides at the same time. Squeegee blades and washers are replaceable.
INSTRUCTIONS FOR CLEANING VERTICAL BLINDS:
With the sponge pads, start at the top of the blind and move down. Release pressure when moving up to prevent the blind from coming off the hook.
INSTRUCTIONS FOR CLEANING LOUVERED WINDOWS:
Wash with the sponge pads, back and forth, until dirt is dissolved. With the squeegee blades, start from the right and move in one single stroke across to the other side. Do not press too hard. If necessary to repeat with the squeegee, be sure to wet each time. For best results, use one stroke, without stopping.
ADJUSTMENT FOR THICKNESS OF GLASS:
1. Loosen the wingnut.
2. Place the squeegee on each side of surface to be cleaned.
3. Grasp the squeegee blade between the thumb and forefinger and press together.
4. Tighten the wingnut and you have the right adjustment.